Operations Manual United Kingdom 1-June-2014
TA9 & 10 Tier 4 Page 7 - 7
Standard Operating Procedures 7
7.7 To Stop the Engine
7.8 To Move the Machine
(1) Moving Off
(2) To Change Gear
(a) Changing Up or Down a Gear
PROCEDURE
1. Stop the machine in a safe position on firm level ground.
2. Apply parking brake and place the forward/reverse switch in Neutral.
3. Place the gear selector lever in Neutral
3. Turn start key anticlockwise to OFF; position.
4. Remove battery isolator key if leaving machine over night.
PROCEDURE
1. Select forward or reverse on the forward/reverse switch.
2. Press and hold the interrupt button on the gear selector lever
3. Select the gear required.
4. Release the interrupt button
5. Release the parking brake
6. Gently press the accelerator pedal until the machine begins to move.
PROCEDURE
1. Reduce engine speed by easing off the accelerator pedal.
2. Press and hold the interrupt button on the gear selector lever.
3. Move the gear selector to the gear required.
4. Release the interrupt button.
5. Gently press the accelerator pedal to increase speed if necessary.
To Next Page
Loading...
Need help?
General
