Troubleshooting 10
1-June-2014 United Kingdom Operations Manual
Page 10 - 2 TA9 & 10Tier 4
(4) Lights and direction indicators do not work
Check circuit breaker has not “tripped”.
Check if bulb has blown.
10.3 Hydraulic Troubleshooting
(1) No Pressure
Check if sufficient oil in tank.
(2) Machine will not steer
Check steering lock is NOT fitted.
Check steering cylinder hoses for leaks.
(3) Skip will not tip
Check hoses for leaks.
10.4 Starting the Engine After Fuel Filter Replacement
Make sure the fuel system has been bled as follows:-
NOTE:- If the engine is cranked or started with excessive air in the HP system or pump serious
damage can occur. In this case Deutz warranty liability is invalid.
PROCEDURE
1. Make sure the replacement filter HAS NOT been pre-filled with fuel.
2. Make sure all pipework, filters etc. are sealed to prevent air entering the system.
3. Turn the key to position ll without cranking the engine and switch off after 30 seconds or
when the fuel pump stops.
4. Turn the key to position ll without cranking the engine and switch off after 30 seconds or
when the fuel pump stops.
5. Turn the key to position ll without cranking the engine and switch off after 30 seconds or
when the fuel pump stops.
6. Attempt to start the engine; if it fails to start after 15 seconds check for leaks and repeat
from step 3.
7. If the engine still fails to start check the ECU for fault codes/call Deutz for assistance.
To Next Page
Loading...
Need help?
General
