Technical Data 3
TC29
21
3.8.2 Fuel, lubricant and coolant specifications
Prescribed fuels, lubricants and coolants for
Central Europe
Application Designation Specification,
Standards, Quality
Remarks
Engine Diesel fuel EN 590
ASTM D975 1-D / 2-D
Before using RME-fuels (rape oil
methyl ester), it is essential to consult your
responsible Terex dealer for further
details.
Engine Engine oil SAE 15W-40
API CF4
See also engine manufacturer’s
instructions
Cooling for engine Coolant Antifreeze based on
ethylene glycol
See also engine manufacturer’s
instructions
Hydraulic system
Hydraulic oil or multi-
grade engine oil
HVLP 46
or
SAE 10W-40
The following viscosity limit values
must be kept (according to ASTM 445)
at 100° C min. 8 mm
2
/s (cSt)
at -10° C approx. 1,500 mm
2
/s (cSt)
Biodegradable hydraulic
oil on synthetic ester
base
Filling according to
customer specifications.
Brand label on machine.
Do not mix
biodegradable oils of
different suppliers.
The same viscosity specifications apply as
for mineral hydraulic oils.
When changing from mineral to
biodegradable hydraulic oils, the tank and
hydraulic system must be completely
drained, cleaned and flushed.
For further details before changing oils,
please consult your responsible Terex
dealer.
Crawler gear units Transmission oil SAE 85W-90LS
API-GL 5
Alternative recommendations
SAE 90LS
SAE 80W-90LS
Lubricating points Multi-purpose, lithium-
soap based grease
K2K-30
DIN 51825
Alternative recommendation for other temperature ranges
Engine oil
according to API CG 4 or CF 4 and
according to ACEA E3 or E2
Hydraulic oil
according to DIN 51524.T3 HVLP
6
To Next Page
Loading...
Need help?
General
