Recovery and Transport 6
TC29
49
6 Recovery and Transport of the Machine
6.1 Recovery of the machine
The recovery of the machine should be
done by use of a crane if possible.
If the machine has to be towed for recovery, the
following tow fixing points are present:
• eye (33/1) on the undercarriage
• two drill holes (33/2) on the dozer blade
6.2 Loading the machine by use of a crane
Only use the original Terex crane lifting
harness!
Use a crane with sufficient weight-lifting
capacity of at least 3,000 kg.
To load the excavator onto a flat bed trailer, etc.,
the following activities must be carried out:
• Empty and fold in the bucket.
• Position the work equipment straight ahead.
• Raise the boom until the height specified.
• Retract the dipperstick.
• Stop the engine.
• Dismount from the excavator and close the
doors.
• Suspend the excavator expertly on the points
marked using the 3-point crane lifting harness.
Take care that the spreader bar (34/1) is
correctly seated.
HR1433
1
2
2
2
Fig. 33-Tow fixing points
HR14-03-34
1
1
c
a
.
3
1
0
ca.1300
Fig. 34- Crane suspension
To Next Page
Loading...
