Terex TC29 User Manual

9 Appendix
TC29
86
9.2 Immobilizer
The immobilizer may only be installed by
the manufacturer of the machine or a
qualified specialist workshop.
The certification of installation in
accordance with specifications must be
filled out by the manufacturer or the
specialist workshop so that it can be
submitted for insurance purposes.
You have installed a self-arming electronic
immobilizer IS 900 safety stop, which works as
follows:
• After the ignition has been switched off, the
system automatically switches to the
immobilization function after approx. 9 minutes.
The green LED goes out and the red LED
begins to flash for as long as the system is
activated.
• If you want to start the vehicle, you must first
enter your personal 4-digit code on the keypad.
If the code has been entered correctly, the red
LED goes out and the green LED lights up to
indicate readiness to start. You must only enter
the code when the ignition is switched off. If
the pressure contact is correct, the green LED
lights up.
• If the code is entered incorrectly, wait approx.
5 seconds before re-entering it.
• If 3 incorrect codes have been entered, the
system is disabled for 8 minutes.
• Before leaving the machine in a workshop, you
should enter a 6-digit code and inform the
workshop personnel of this when you hand the
key over. This code is retained until you enter
your personal code again. The workshop code
is then canceled automatically.
• Inform the workshop that when the workshop
code applies, the system only arms itself after
30 minutes.
Coding:
The immobilizer installed in your vehicle has the
following code, which has been applied at the
factory: 0001
Entering or changing the personal code
(If the pressure contact is correct, the green LED
lights up.)
No more than three identical numbers
are accepted!
1. Enter the factory code "0-0-0-1" or your
personal code until the green LED lights up.
2. Immediately press "1" until the green LED
flashes 4 times and goes out.
3. Now immediately enter the new code (e.g., "6-
7-8-9") by pressing the numbers you have
chosen in the correct sequence.
4. Immediately press "1" until the green LED
flashes 4 times and goes out.
5. Immediately enter your personal code again.
6. Immediately press "1" until the green LED
lights up.
7. The new code is now permanently
programmed.

Terex TC29 Specifications

General

Brand	Terex
Model	TC29
Category	Excavators
Language	English