22
Power Supply, Testing Computer:
Only the power cable supplied by the manufacturer (ADS18B-B
120100) vshould be used. Charge the device only in dry,
indoors locations. The inner pole is the positive (+) pole.
Type ADS18B-B 120100 (OEM Co., Ltd.)
Prim: 100-240V AC, 50-60Hz, 0,5A Class II
Sec: 12V/1,0A
IP20
First plug the power cable into the appropriate ‘12V / max.
1.25A’ socket of the testing computer, located on the top left of
the control panel, beside the GPS antenna. Then plug the other
end of the cable into the wall socket.
When disconnecting the cable always take hold of the plug.
Pulling on the cable may result in damage to the wires.
Power Supply, Bluetooth
®
Load Plate
‘TERRATEST 6000 BLE’:
Only the power cable supplied by the manufacturer (SYS1308-
1809-W2E) with LEMO-plugs should be used for charging the
Bluetooth
®
transmitter in the Bluetooth
®
sensor dome. The LEMO
connector after insertion is self-locking by means of a push-pull
coupling, thus protecting the cable against removal by mistake. To
open the push-pull coupling, first slide back the outer sleeve of
the connector. Charge the device only in dry, indoors locations.
The inner pole is the positive (+) pole.
Type: SYS1308-1809-W2E with LEMO-plugs
Prim: 100-240V AC, 47-63Hz, 1A Class II
Sec: 9V/2A
IP20
First plug the power cable into the socket of the Bluetooth
®
sensor
dome. Then plug the other end of the cable into the wall socket.
When disconnecting the cable always take hold of the plug.
Pulling on the cable may result in damage to the wires.
The power cable for the Bluetooth
®
load plate ‘TERRATEST 6000
BLE’ is equipped with a plug with LEMO ‘PUSH-PULL’ lock and
anti-kink protection. The LEMO connector after insertion is self-
locking by means of a push-pull coupling, thus protecting the
cable against removal by mistake. To open the push-pull coup-
ling, first slide back the outer sleeve of the connector. For this rea-
son, for unlocking only grasp from the plug housing, otherwise
cable or socket can be damaged. Charge the device only Failure
to do so may cause damage to the cable or socket.
To Next Page
