Chapter 3 – Composer Software
Page 36 TestEquity F4T Controller
Creating and Editing Profiles in Composer Software
This section describes the features of the Profile View in Composer Software and includes
instructions for using it. A profile is a set of instructions consisting of a sequence of steps. When
a profile runs, the controller automatically executes its steps in sequence.
Profile View Orientation: Describes the layout of the profile screens.
Profile Parameters: Settings that apply to a profile.
Step Parameters: Settings that apply to a step.
Opening the Profile View: Displays the list of profiles in the device.
Creating Profiles: Up to 50 profiles can be created.
Saving a Profile: Store profiles on the computer to make it easy to load them in other controllers
or to restore one that was inadvertently changed or deleted from the controller.
Loading a Profile: Loads a profile that was previously saved to the controller’s memory.
Duplicating a Profile: An easy way to create a new profile similar to one that was created
previously.
Deleting a Profile: Removes unneeded profiles from the controller memory freeing up space for
new profiles.
Opening the Step Editor: Displays the details of the step.
Adding Steps: Up to 50 steps can be included within any given profile.
Inserting Steps: Create a new step at a specific point in a profile.
Deleting Steps: Remove a step from a profile.
Password Protect a Profile: Avoid unwanted and inadvertent changes to a profile with
password protection.
Changing or Removing a Password from a Profile: When password protection is no longer
needed it can be easily removed.
To Next Page
Loading...
Need help?
General