Chapter 3 – Composer Software
Page 32 TestEquity F4T Controller
Import System Image
Located in System ②. Restores a system image from a storage device to the controller. The list
below shows what is restored:
• Device Details
• Pluggable Modules
• Function Block Diagram in its entirety
• System Security
• Profiles
• Profile passwords
• All parameters that can be read and written to
Importing a System Image
NOTE: We recommend changing the IP Address Mode to Fixed instead of DHCP when
importing a system image. You might need help from your IT department to configure your
computer to match this setting.
To import a system image:
1. On any Composer screen click System and then Import Image.
2. Use the open dialog to select the folder location for the previously saved system image.
3. Double-click the desired filename or single-click the filename and then click the Open
button.
4. After a system image is imported, we suggest you cycle power to the F4T Controller and
restart Composer software.
To Next Page
Loading...