Chapter 2 – Using the F4T Front Panel
Page 26 TestEquity F4T Controller
Operations Page
Control PID Loops
Provides access to the Loop Operational Parameters as
described in the section which proceeds this.
Profile Events
Provides access to all Event Outputs. See “Controlling
the Events” in Chapter 5.
Inputs
Provides a view of the sensor inputs and any other input which the controller has been
configured for.
Outputs
Provides a status of the controller’s outputs. This screen is read-only.
Alarms
Provides a view of the alarm settings. NOTE: Models 106/107 and all models with Humidity use
these alarms for system functions and should not be changed.
! CAUTION: The Series F4T “Alarm” functions are NOT used in the chamber’s safety
system. TestEquity does NOT recommend using the Series F4 alarm function
as the main protection device. The independent EZ-Zone Limit Controller
functions as the main protection device.
Machine Controls
Provides a view of any internal system variables. This function is not used.
Screen Snapshot Utility
Firmware Version 03:02:0010 and above include the
ability to take a Snapshot of any screen. Snapshot
functionality is enabled under the Help menu. To turn
this function on, press the “?” button and then press
the Enable camera icon. The icon will change from
Enable to Disable.
Insert a USB thumb drive into the USB host port on
the chamber. When Snapshot is enabled, a tap of the
“?” button will take a snapshot of the screen and store it on the USB thumb drive. The snapshot
file will be saved in a .bmp format.
To disable the Snapshot function, press the Menu button and then the Help icon (you may have
to scroll the screen to the end to see the Help icon). Then press the Disable camera icon. The
icon will change from Disable to Enable.
To Next Page
Loading...