3
Repeat steps
1
and
2
as required.
4
Save the input:
OK Save input .
E.4.4 Printing data
Data are printed out via the function key . The function is only available if a prin-
tout is possible.
If data are to be transferred to a protocol printer via the infrared or Bluetooth interface,
the printer that is to be used must be activated, see
Printer
, p. 28.
E.4.5 Saving data
Data are saved either via the function key or the function field OK Save input. The
functions are only available if saving is possible.
See also
Memory
, p. 22.
E.4.6 Confirming an error message
If an error occurs, an error message is shown in the display.
To confirm an error message: .
Errors which have occurred and have not yet been rectified are shown by a warning
symbol in the header ( ).
Messages for errors which have not yet been rectified can be viewed in the
Error diagno-
sis
menu, see
Instrument diagnosis
, p. 26.
E.4.7 Switching the measuring instrument off
Unsaved readings are lost when the measuring instrument is switched off.
.
- Possibly: The pump starts and the senors are rinsed until the shutoff thresholds
(O
2
>20%, other parameters <50ppm) are reached. Rinsing lasts no more than 2
minutes.
- The measuring instrument switches off.
OK
Save
Print
OK
E. Operation
21
To Next Page
Loading...
