TESTO 340 - Measuring Programs

Measuring:
1
Start measuring: .
- The readings are displayed.
Option:
Interrupt measurement and rinse sensors: ,
Continue measurement: .
2
Stop measuring: .
Options:
To print readings: .
To save readings: .
- The readings from the flue gas measurement, as well as any readings taken over
into the menu
Flue Gas from other measurement functions are stored and/or prin-
ted in a measurement protocol (automatic furnace data are not printed).
G.2.2 Program
Five flue gas measuring programs can be set, saved and run.
Calling up the function:

Measurements Program  .
Changing a measuring program:
1
Select the program  .
2
Meas rate   Enter the values  .
3
Repeat step
2
for the other criteria accordingly.
4
OK Save input .
Running a measuring program:
1
Select the program  .
2
Select
Start without zeroing (only available if gas zeroing has already been carried out)
or
Start with zeroing and start the program with .
- If selected: Gas zeroing (32 s).
- Stabilisation phase (60 s).
- The program will run and then stop after the programmed time.
Option:
To print readings: .
To cancel the program: , start again: .
StartStop
Print
OK
Start
OK
OKChange
Change
OKOK
Save
Print
Stop
Gas
Air
Start
G. Measuring
39