TESTO 340 - Gas Flow Rate Measurement

Recording smoke tester no./smoke numbers/ oil derivative with the smoke tester
testo 308 and wireless transfer:
-
t308
must be in Data Mode ( ).
1 Press function key .
- The values recorded by the smoke tester are transferred.
2 Once all values have been transferred, select function key .
Entering the heat carrier temperature:
Heat carrier Enter the value  .
Copying values to the Flue gas menu:
The values are not shown on the instrument's display. In the menu
Flue Gas, they can
be stored and/or printed in a measurement protocol together with the readings from
a flue gas measurement, or transferred to a PC
OK Copy readings  .
- The
Measurements menu is opened.
G.2.5 Gas flow rate
The Gas flow rate function is only available if the activated fuel is a gas.
Calling up the function:

Measurements Gas flow rate  .
Measuring:
1
Enter the measurement period:
Sample time Enter the value (18, 36, or
180
seconds)  .
2
Start measuring: . Note the counter status of the gas counter.
- The remaining measurement period is displayed.
- When the measurement period has lapsed, a long beep is emitted. The last 5 s are
indicated by a short beep.
3
Enter the flow rate:
Gasflow  Enter the value  .
- The calculated gas burner output is displayed.
4
Copy the values to the
Flue gas menu: OK Copy readings  .
- The
Measurements menu is opened.
OK
OK
Start
OK
Change
OKOK
OK
OKChange
OK
t308
G. Measuring
41