E.5.2 Location
Creating a new location:
A location is always created in a folder.
1
Select the folder
New location .
2
Select the
Location name .
3
Enter values
OK Save input .
4
Repeat steps
2
and
3
for the other criteria accordingly.
5
OK Go to measurement or OK To location .
Ordering the locations list:
1
Select the folder .
2
Locations list .
Activating a location:
Select the folder Select location .
- The location is activated and the
Measurements menu is opened.
Restoring the locations list:
To arrange the list in the order in which the folders were created:
Select the folder
Restore list .
Delete a location:
1
Select the folder .
2
Select the location .
3
Select
Delete site with data .
Performing location settings:
For flow speed, air flow and mass flow to be measured correctly, the shape and surface
area of the cross-section must be set.
The parameters
Pitot factor and Offset factor influence the measurement of flow speed, air
flow and mass flow. The pitot factor depends on the type of pitot tube that is used.
The offset factor should be set at 1.00 for all standard applications.
OK
Edit
OK
OKOK
OKOK
OK
OK
OK
OK
Change
OKOK
E. Operation
23
To Next Page
Loading...
