TESTO 340 - Measurement Protocols

The parameters Temp./amb. (ambient air temperature), Hum/amb. (ambient air humidity)
and
Dew p./amb. (ambient air dew point) influence calculation of the qA (Flue gas loss)
and DP (Flue gas dew point temperature). The parameters should be set to the factory
settings for all standard applications (Temp./amb.: 20.0 °C, Hum/amb.: 80.0 %, Dew
p./amb.: 16.4 °C). To achieve greater accuracy, the values can be adjusted to the actual
ambient conditions.
If the ambient air temperature sensor is plugged in, the value for Temp./amb. is accep-
ted automatically. The parameter
Dew p./amb. can be calculated from the values of
Temp./amb. and Hum/amb. via the function key .
1
Select the folder  .
2
Select the location  .
Options:
To set the shape of the cross-section:
Cross section Select the cross-section  .
To set the surface area of the cross-section:
Cross section Select the cross-section Set the values 
.
To set parameters:
Select the parameter Set the values  .
3
OK To location  .
E.5.3 Protocols
Printing/deleting all protocols:
Select the folder Select a location  .
- The saved protocols are displayed. Protocols of measurement programs are marked
with a vertical line and the number of individual measurements (e.g.
|245), for more
than 999 measurements dots are used (
|...). If automatic furnace data are stored with
a measurement protocol the following symbol is displayed next to the protocol name:
. The data are printed with the protocol printout.
Options:
To print all data: Print all  .
To delete all data: Delete all  .
OK
OK
DataOK
OK
OKChange
OK
ChangeChange

Change
Edit
OK
calc
E. Operation
24