TESTO 340 - Functional Overview; Flue Gas Measurement Tasks; Memory Function Summary

Functional overview
The table gives an overview of the most important functions configured on the individual
instruments. Detailed information about the individual functions can be found on the
pages indicated.
Task Call/function see page
 Measurements 
Flue gas measurement Flue gas  38
Flue gas measurement with parallel flow measurement Flue gas + m/s 
(+ air/mass flow calculation) 38
Flue gas measurement with parallel differential Flue gas +
ΔΔ
p2 
pressure measurement 38
Change/save/run measuring program Program  39
Draught measurement Draught  40
Enter smoke #/heat carrier temperature Smoke # / HCT  40
Determine gas flow rate Gas flow rate  41
Determine oil flow rate Oil flow rate  42
Flow speed and pressure measurement m/s  42
Pressure measurement
ΔΔ
p2  43
Read automatic furnace Burner control  43
 Memory 
Create new folder New folder  22
Sort folder list by Folder, Name or Addr’ Folders list  or or 22
Sort locations list by order of creation Restore list  22
Create new location Folder   New location  22
Sort locations list by location name Folder   Locations list  22
Sort locations list by order of creation Folder   Restore list  22
Activate location Folder   Select location  22
Perform location settings Folder   Select location  22
Display measurement data of one location Folder   Select location  22
Print all measurement data of a location Folder   Select location  
Print all  22
Delete all measurement data of a location Folder   Select location  
Delete all  22
Display readings of a selected measurement protocol Folder   Select location  
Select protocol  22
Print a single measurement protocol Folder  Select location  
Select protocol  22
Print
DataOK
Value
DataOK
OK
DataOK
OK
DataOK
DataOK
ChangeOK
OKOK
OKOK
LocatOK
OKOK
OK
Addr’NameFolder
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
Functional overview
60