Chapter 13: Link and the CBL
à
CBR Application
271
APPS.DOC Chapter 13: Link and CBL/CBR Application, English Julie Hewlett Revised: 02/07/01 10:34 AM
Printed: 02/07/01 10:35 AM Page 271 of 22
INTRVL (SEC)
INTRVL
(SEC)
specifies the interval in seconds between each
data sample that is collected. For example, if you want to
collect 99 samples and
INTRVL=1
, it takes 99 seconds to finish
data collection. Enter values using the number keys. See the
CBR or CBL 2/CBL guidebook for more information about
interval limits.
UNITS
The results are displayed according to the
UNITS
specified. To
specify a unit measurement (
Temp
or
Sonic
only), highlight the
one you want using the cursor keys, and then press
b
.
PLOT
You can specify whether you want the calculator to collect
realtime (
RealTme
) samples, which means that the calculator
graphs data points immediately as they are being collected, or
you can wait and show the graph only after all data points
have been collected (
End
). Highlight the option you want with
the cursor keys, and then press
b
.
Ymin and Ymax
To specify
Ymin
and
Ymax
values for the final graph, press
'
to view the
PLOT WINDOW
screen. Use
$
and
#
to
move between options. Enter
Ymin
and
Ymax
using the number
keys. Press
-
l
to return to the
DATA LOGGER
options
screen.
DIRECTNS (Directions)
If
DIRECTNS=On
, the calculator displays step-by-step directions
on the screen, which help you set up and run the data
collection. To select
On
or
Off
, highlight the one you want with
the cursor keys, and then press
b
.
With the
Sonic
data collection probe, if
DIRECTNS=On
, the
calculator displays a menu screen before starting the
application asking you to select
1:CBL
or
2:CBR.
This ensures
that you get the appropriate directions. Press
1
to specify
CBL
or
2
to specify
CBR
.
To Next Page
Loading...
Need help?
General
