Appendix C: IPMI
Configuring IPMI Network Settings
DSM Installation and Configuration Guide
Copyright 2009 - 2020 Thales Group. All rights reserved.
150
Function User Operator Administrator
Sensor Readings Full Access Full Access Full Access
Event Log View Only Full Access Full Access
Alert No View Only Full Access
LDAP No View Only Full Access
Mouse Mode No Full Access Full Access
Network No View Only Full Access
Remote Session No View Only Full Access
SMTP No View Only Full Access
SSL No View Only Full Access
Users No View Only Full Access
Event Action No View Only Full Access
Power Control View Only Full Access Full Access
KVM View Only Full Access Full Access
F/W Update View Only View Only Full Access
SDR Update View Only Full Access Full Access
Logout Full Access Full Access Full Access
To create users and assign privileges:
1. Click Configuration > Users.
2. To add a new user to the network, select an empty slot from the users list.
3. Click Add User.
4. Enter the following information:
a. User Name
b. Password
c. Confirm password
d. Network Privileges
5. To modify the information or the status of a user, select a user and then click Modify User.
6. To delete a user from the network, select a user from the users list and then click Delete User.
Note
The User ID #1 (Anonymous) is reserved and cannot be modified or deleted. The User ID #2 (ADMIN)
cannot be deleted. You can only modify the name and password.
Configuring IPMI GUI Port Settings
You can configure the following ports for IPMI on the V6000/V6100 DSM hardware appliance.
To access:
To Next Page
Loading...
