Thales V6000 - Configure DSM Ports; Configuration Tasks

Chapter 2: DSM V6100 Hardware Appliance
Configuring a V6100 Appliance
DSM Installation and Configuration Guide
Copyright 2009 - 2020 Thales Group. All rights reserved.
27
l
Files: Search local files (/etc/hosts)
Host Search 1 Search 2
dns files
Network DNS Server local /etc/hosts file
files dns
local /etc/hostsfile Network DNS Server
The DNS show command now displays the DNS servers and the order for name resolution.
Example
0001:network$ dns show
nameserver 192.168.110.224
nameserver 192.168.110.104
hosts: files dns
DNS show SUCCESS
If you type dns switchhosts, the dns show command shows that the DNS name resolution has been reversed:
0002:network$ dns switchhosts
Switched hosts sources in nsswitch.conf.
0003:network$ dns show
nameserver 10.3.110.224
nameserver 10.3.110.104
hosts: dns files
DNS show SUCCESS
Configure DSM ports
If a DSM is to communicate with a device behind a firewall, you must open various ports in the firewall.
l
To see the ports to configure, see "Ports to Configure" on page171
Configuration tasks
When you configure the DSM Appliance, you must:
1. "Connect to the V6100 appliance" on the facing page
2. "Access the DSM Command Line Interface (CLI)" on page51
3. "Configure network settings" on page77
4. "Configure a bonded NIC device" on page79
5. "Bonding driver modes" on page80
6. "Enable DHCP on bond0 interface" on page81
7. "Configure NTP, time zone, date, time" on page81
8. "Configure the hostname" on page82
9. "Verify Web Access" on page85
10. "Upload a license file" on page85