Chapter 2: DSM V6100 Hardware Appliance
Configuring a V6100 Appliance
DSM Installation and Configuration Guide
Copyright 2009 - 2020 Thales Group. All rights reserved.
29
0036:dsm$ ?
network Networking configuration
system System configuration
hsm HSM configuration
maintenance System maintenance utilities
ha HA configuration
ipmi IPMI configuration
user User configuration
exit Exit
To enter a submenu, enter a name or just the first few letters of the name. To display the commands for that submenu,
enter a ‘?’. For example, the submenu maintenance is used to provide maintenance utilities:
0037:dsm$ maintenance
0038:maintenance$ ?
config Save/load configuration file
showver Show the installed VTS version
delver Delete unused firmware version
ntpdate Set ntp services
date Set system date
time Set system time
gmttimezone Set system time zone
diag OS diagnostics
up Return to previous menu
exit Exit
Every command has a usage and example input. Type the command without a value:
0039:maintenance$ ntpdate
usage: ntpdate {sync | add SERVER_ADDRESS | delete SERVER_ADDRESS | on | off | show }
0040:maintenance$ date
month=Mar day=17 year=2015
Show system date SUCCESS
0041:maintenance$ time
hour=11 min=11 sec=36 zone=PDT
Show system time SUCCESS
0042:maintenance$ gmttimezone
usage: gmttimezone {list|show|set ZONE_NAME}
0043:maintenance$ diag
usage: diag [log [ list | view LOG_FILE_NAME] | vmstat | diskusage | hardware | osversion |
uptime ]
0044:maintenance$
You must enter a submenu to execute the commands in that submenu. For example, the reboot command is in the
system submenu, you would type system and press enter to enter the system submenu, then type reboot to execute
the reboot command. To return to the main menu when finished, type up.
A complete description of all the DSM CLI commands can be found in the DSM Administrators Guide.
Configure network settings
1. Navigate to the network commands menu. Type:
0001:dsm$ network
2. Configure an IP address for the DSM. Type,
To Next Page
Loading...
