Thales V6000 - DSM Installation Checklist

Chapter 2: DSM V6100 Hardware Appliance
Configuring a V6100 Appliance
DSM Installation and Configuration Guide
Copyright 2009 - 2020 Thales Group. All rights reserved.
24
Configure appliance with static IP address enabled
1. Assemble required information using the "DSM Installation Checklist" below
2. "Specify host name resolution method" on page26, if required
3. "Configure DSM ports" on page27, if applicable
4. "Configuration tasks" on page27
5. "Configuration tasks" on page27, if you choose to use this feature
6. "Configuration tasks" on page27
7. "Configuration tasks" on page27
8. "Enable remote administration" on page39
9. "Generate DSM Certificate Authority and create ACS" on page82
10. "Configuring High Availability for V6100" on page45
11. "Add more CLI administrators (optional)" on page62
Assumptions
l
Data center conditions meet the appliance racking, networking, and power requirements.
l
The IP address, routing configuration and DNS addresses for the DSM allow connectivity to all servers where
Vormetric Encryption Agents are installed.
DSM Installation Checklist
Use this table to collect the information you need for the installation.
REQUIREMENT VALUE
Hardware Requirements
Two power outlets with an independent, 120/240V,
47/63Hz, 12/6A power source.
Serial console—this should be connected to the DSM
appliance using the serial cable included with the
appliance.
Two network (Ethernet) cables, these are included with the
DSM appliance.
Trusted verification device (TVD) and set of smart cards
(V6100 only)
Laptop or PC to connect the TVD (V6100 only)
1u rack space
Network Information