At this time, the virtual IP address will be mapped to the PMS system because it is
in an active state.
HA Ready:
After both Primary and Secondary systems has rebooted, the HA link status and the
HA RAID volume can be seen from the HA status page.
Please note, it will take 1~2 minutes to complete the primary and secondary
servers’ role played. If both servers are displayed as standby, please wait for the
systems to synchronize with each other.
From the HA Primary server “PMA (172.16.66.25)” it will denote the role of “Active”
and for the “PMS (172.16.66.24)”, it will show the role as Standby.
The HA RAID volume status can be found as shown in the screen shot below.
The user can access this newly create HA system by its virtual IP. Using widows, the
user can simply input 172.16.64.87 or HApm in the navigation bar then the
available share files will be listed as below:
To Next Page
Loading...
