THERA-Trainer tigo / THERA-Trainer veho - User manual
48
Art. No.: A002-629_Rev 06
Last update: CW19/2018
Pulse indicator Only in combination with control and display unit and cardio-pulse-set
(only for 5.7" and 10.4" control and display unit)
Indicates the user's current pulse rate.
Reduces exercising resistance as soon as the set pulse rate is reached.
The user's pulse rate during the training session always stays below the
limit set by the doctor.
Power display
Shows performance in watt.
Exclusively for active muscle training.
Covered
distance
Shows total distance covered in km.
Remaining
training time
Indicates remaining training time.
Wireless
connection
Connection symbol without X: Existing wireless connection between
a THERA-Trainer and a PC.
Connection symbol with X: No existing wireless connection between
a THERA-Trainer and a PC.
If connection symbol with X is displayed:
Check that
– Group therapy / THERA-soft training programme is selected.
– PC with group therapy / THERA-soft installed is switched on.
– CL group therapy / THERA-soft software on PC is opened and launched.
– PC is within range of wireless connection (approx. 5 metres).
– Wireless receiver is correctly connected.
– PC is correctly connected to mains.
– The correct wireless connection is assigned in the sub menu.
If no connection is established after the possible causes listed above have been
checked and ruled out:
Select a different training programme and return to training programme group
therapy / THERA-soft from there. More information for setting up a wireless
connection see chapter 14.1 Sub menu.
Voice-controlled
emergency stop
Indicates that voice-controlled emergency stop is switched off.
Button lock on
Shows that the button lock is activated.
Speakers off
Shows that the speakers are switched off.
Display
Biofeedback
Shows biofeedback Symmetry bar or Symmetry road as factory setting.
It is still possible to adjust settings for 30 secIt is possible to set further
biofeedback illustrations in the sub menu.
To Next Page
