THERA-Trainer TIGO - Troubleshooting; Control and Display Unit Tigo;Veho 2.7 Wireless Errors

71
Art. No.: A002-629_Rev 06
Last update: CW19/2018
THERA-Trainer tigo / THERA-Trainer veho - User manual
18 TROUBLESHOOTING
18.1 Control and display unit tigo/veho 2.7" wireless
NoteUp to error message E045, the control and display unit shows error messages
for approx. 3 seconds. This is followed by an automatic restart.
From error message E128, the control and display unit shows error messages
permanently. There is no automatic restart.
 Observe troubleshooting instructions.
Error code Troubleshooting
E007 Main controller board defective.
Contact trained supplier.
E009 Cabling faulty or defective.
Contact trained supplier.
E016 Cabling faulty or defective.
Contact trained supplier.
E035 Pull out power plug and plug it back in after approx. 5 seconds.
THERA-Trainer boots up.
If error message occurs repeatedly:
Contact trained supplier.
E036
Pull out power plug and plug it back in after approx. 5 seconds.
THERA-Trainer boots up.
If error message occurs repeatedly:
Contact trained supplier.
E039
Pull out power plug and plug it back in after approx. 5 seconds.
THERA-Trainer boots up.
If error message occurs repeatedly:
Contact trained supplier.
E040 Cabling faulty or defective.
Contact trained supplier.
Possibly. Have main controller board replaced.
E041 Main controller board defective.
Contact trained supplier.
E044 Cabling faulty or defective.
Contact trained supplier.
Replace main controller board and/or control and display unit
tigo/veho 2.7" wireless
E045 The upper limits for the number of rotations/power are exceeded.
The THERA-Trainer terminates the training session.
Reduce exercising resistance or number of rotations.
Make sure that the user does not exceed the upper limit for number
of rotations (95 rpm) and power (80 Watt).