THERA-Trainer tigo / THERA-Trainer veho - User manual
74
Art. No.: A002-629_Rev 06
Last update: CW19/2018
18.3 General errors
Error code Troubleshooting
The THERA-Trainer
has too little power
Reduce crank radius setting.
Increase motor power by one level.
Damage to tendons or joints due to overstraining is possible.
Before changing settings, consult therapist.
Spasm detection
responds too often
Reduce sensitivity of spasm detection.
Reduce crank radius setting.
Increase motor power by one level.
Optimise sitting position and distance to unit.
Damage to tendons or joints due to overstraining is possible.
Before changing settings, consult therapist.
Exercising resistance
is too high for active
muscle exercise
Increase crank radius setting.
Reduce motor power.
Training programme Neuro:
Reduce exercising resistance setting.
Training programme Ortho and Cardio:
Reduce target performance.
Pulse monitor is not
working (only for control
and display unit with 5.7"
or 10.4" colour screen
with cardio-pulse-set)
Check if transmitter (in chest belt) and receiver (in control
and display unit) are correctly positioned.
Correct if necessary.
Check if chest belt is moistened, correctly tightened and
touching the skin.
Correct if necessary.
THERA-Trainer is running
irregularly
Activate motor muscle support (only for control and display
unit with 5.7'', 7" or 10.4'' colour screen).
Check if crank radius setting is the same on both sides.
Correct if necessary.
Check if user is sitting exactly in the centre (axial position).
Correct if necessary.
If fault occurs repeatedly:
Contact trained supplier.
Operating the
THERA-Trainer
is not possible
Make sure that START button has been pressed.
It is possible that THERA-Trainer is in stand-by mode.
Make sure that power supply cable is intact and correctly
connected.
Check mains fuse.
Pull power plug and plug it back in after approx. 5 s.
Press START button.
Make sure that correct exerciser type (arm or leg)
is selected.
Make sure that cranks are unlocked for upper body
exercise.
THERA-Trainer does not
show a training evaluation
Exercise for at least 1 min.