THERA-Trainer tigo / THERA-Trainer veho - User manual
78
Art. No.: A002-629_Rev 06
Last update: CW19/2018
21 NOTES ON ELECTROMAGNETIC COMPATIBILITY
21.1 Lines, line lengths and accessories
The THERA-Trainer is to be exclusively used with the original power supply cable.
21.2 Warning notice regarding accessories
Exclusively the manufacturer's cardio-pulse-set may be used.
21.3 Warning notice regarding installation
The THERA-Trainer is not to be used in the immediate vicinity of or stacked with
other devices. If it is necessary that the THERA-Trainer is used next to or in a stack
with other devices, one should observe it to check if the arrangement permits it to
work as intended.
21.4 Electromagnetic emission and immunity
Note Does not apply to control and display unit 5.7".
The device is classified according to CISPR 11 in Group 1 Class B;
for immunity test levels it is designed according to DIN EN 60601-2:2016-05
(EN 6060 1-2:2015, IEC 60601-1-2:2014) for the environment as intended
use of Table 4, 5 and 9.
Deviations or simplifications regarding the above-mentioned immunity test
levels are inadmissible.
Maintenance activities to maintain basic safety and essential performance
characteristics are not required within the expected service life of 7 years.
21.5 Wireless reception and transmission of HF energy
of the control and display unit
Note Only valid for control and display unit tigo/veho 2.7" wireless.
Sender information / receiver information
– Frequency band (ISM band): 2.400 GHz - 2.4835 GHz
– Useful frequency band: 2.402 GHz - 2.480 GHz
– Channel width: 40 channels at 2 MHz
– Modulation: GFSK (Gaussian Frequency Shift Keying)
– Effective Radiated Power (EIRP): -4 dBm
21.6 User Information acc. to FCC15.21
Note Only valid for control and display unit tigo/veho 2.7'' wireless.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
To Next Page
