65
Art. No.: A002-629_Rev 06
Last update: CW19/2018
THERA-Trainer tigo / THERA-Trainer veho - User manual
Apply polar pulse belt as follows:
Attach transmitter 1 to elastic belt 2 with clip buckle.
Moisten transmitter slightly for better conductivity.
Apply transmitter centrally below the chest (solar plexus close to the heart).
Put belt around upper body and close with clip buckle.
Make sure that transmitter is touching the skin.
Make sure that polar logo is on the outside.
Make sure that cardio-pulse-set does not slip.
Make sure that cardio-pulse-set is not too tight.
If pulse monitor is working correctly, control and display unit shows
pulse rate.
solid red heart symbol.
Clean cardio-pulse-set as follows:
Rinse under flowing water with mild soap rinse after use.
Hang to dry.
15 MOTOR POWER/JOINT FORCE
15.1 Motor power
The motor power
is adjustable individually for every training programme and every user.
has a stronger effect on the user's legs/arms with a small crank radius than
with a large crank radius.
limits the motor's maximum drive power.
for the leg exerciser is adjustable between 2 and 22 Nm.
for the upper body exerciser is adjustable between 2 and 8 Nm.
NOTE!
Material damage due to incorrect cleaning or drying!
Never use cleaning agents that are chemical, aggressive or caustic, or contain
solvents.
Do not use moisturising soap.
Do not tumble dry or iron.
CAUTION!
Risk of injury due to inappropriate motor power.
Check the configured motor power before every training session and adjust it to
the user’s fitness level.
To Next Page
Loading...
