THERA-Trainer TIGO - Page 59

59
Art. No.: A002-629_Rev 06
Last update: CW19/2018
THERA-Trainer tigo / THERA-Trainer veho - User manual
Operating hoursDisplay of operating hours in hours for:
– Upper body training
– Leg exercise
–Total
ConfigurationIt is possible to set the necessary configuration under menu item Configuration.
 The configuration requires an access code and is only to be used by trained
suppliers.
Time/date Set date and time in sub menu:
 When switching between summer and winter time.
 After THERA-Trainer has been without power supply for a long time.
 For training documentation and evaluation with software package Cycling
documentation and evaluation.
Wireless
connection
Requirements:
 Wireless receiver (A006-672) must be plugged into the USB interface
of the control and display unit.
 PC requirements to set up a wireless connection.
– activated Bluetooth
-OR-
– Wireless receiver is plugged into the USB interface of the PC.
 Requires group therapy + THERA-soft for the training programmes
 Wireless symbol indicates existing connection.
 In the Technology section in the sub menu, click on wireless connection.
Two group therapy / THERA-soft areas are displayed.
 Select one of the areas.
A search for all wireless connections within a radius of 5 meters is then made.
 Select the relevant PC.
When the training programme group therapy / THERA-soft is selected, an attempt
is made to set up a wireless connection.
NoteFurther information can be found in the group therapy / THERA-soft user manual.
Basic training
settings
 See table Menu structure.
 Settings will remain unchanged if the power supply is cut off. The training
session will start with the same settings.
Factory settingsReset to factory settings:
 Press and hold STOP button.
 Press button Direction of rotation at the same time.
Factory settings are restored.
The settings in the section System remain unchanged.