THERMACUT EX-TRAFIRE 125HD - Page 35

EX-TRAFIRE
®
125HD 10 Faults and troubleshooting
EN - 35
H19
 Incorrect current
setting.
 Verify the cutting power
settings.
H20
 Incorrect cutting mode.  Verify the cutting mode.
H21
 Gas pressure fault.  Check the gas supply.
H23
 Torch trigger is pressed
before starting or
during initialization.
 Verify that the trigger is not
pressed when the power
supply is switched on, and
during initialization.
Table 12 Fault messages in the display
Error code Cause Troubleshooting