EasyManuals Logo

Thermal Dynamics CUTMASTER 60i Service Manual

Thermal Dynamics CUTMASTER 60i
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
CUTMASTER 60i
SERVICE Manual 0-5475
5-42
3. Remove the two M5x0.8x16mm hex screws, at the rear of the unit holding the filter assembly in place.
Remove these
two screws
Art # A-13314
4. Remove the entire assembly out through the rear of the unit
Remove the
assembly
Art # A-13315
Proedure is now complete.

Table of Contents

Other manuals for Thermal Dynamics CUTMASTER 60i

Preview: Operating Manual
Operating Manual90 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermal Dynamics CUTMASTER 60i and is the answer not in the manual?

Thermal Dynamics CUTMASTER 60i Specifications

General IconGeneral
BrandThermal Dynamics
ModelCUTMASTER 60i
CategoryWelding System
LanguageEnglish

Related product manuals