Thermo King T- series User Manual

40
UNIT OPERATING INSTRUCTIONS PREMIUM HMI CONTROLLER
To enter a Wake-up Time, verify the unit clock
is set properly. Then press the YES key at the
Sleep Mode menu.
Yes Key
The display will prompt the operator for the
DAY the unit is to restart in normal operation.
In figure shown Monday has been chosen.
Press the YES key to confirm the DAY.
Day Unit is to Restart
The display will now prompt the operator for
the Hour the unit is to restart in normal
operation. In figure shown 4:00 am has been
chosen. Press the YES key to confirm the
HOUR. Note that 24 hour "military time" is
used.
Confirm Hour
The display will now prompt the operator for
the MINUTE the unit is to restart in normal
operation. In figure shown 4:30 am has been
chosen. Press the YES key to confirm the
MINUTE.
Confirm Minute
The display will now prompt for a Pretrip Test
on Wake-up. Press the YES key to perform a
Pretrip Test on Wake-up. If the No key is
pressed the unit will resume normal operation
on Wake-up.
Press Yes Key for Pretrip Test
The display will show SLEEP and the unit will
start and stop as required to keep the engine
warm and/or the battery charged. Sleep mode
does not consider setpoint or maintain cargo
temperatures.
Sleep Mode
The unit will restart at the programmed time (in
this example 4:30 am) and perform a Pretrip
Test (if selected). After the Pretrip Test is
complete the test results will be displayed and
the unit will resume normal operation and
control to setpoint.
To exit Sleep Mode before the selected
Wake-up time press the EXIT key or turn the
unit off and back on. The unit will resume
normal operation and control to setpoint.

Thermo King T- series Specifications

General

Refrigerant	R-404A
Voltage	12V/24V DC
Defrost	Electric or Hot Gas
Model	T-series
Cooling Capacity	Varies by model
Power Source	Diesel Engine or Electric
Temperature Range	-29°C to 24°C
Control System	Microprocessor-based
Fuel Tank Capacity	Varies by model
Dimensions	Varies by model
Weight	Varies by model