EasyManuals Logo

Thermo King T- series User Manual

Thermo King T- series
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
44
UNIT OPERATING INSTRUCTIONS PREMIUM HMI CONTROLLER
NOTE: This screen will not appear if diesel to
electric autoswitching is enabled.
If the unit has standby power available and is
turned on, the electric standby run screen will
appear. The new mode is then confirmed for 10
seconds. The unit will start and run in electric
mode. If electric standby power is not
available the display will prompt for a return to
diesel mode as shown below.
Electric Standby Run Screen
If the electric standby power source fails or is
disconnected and manual switching to diesel
mode is selected, the unit will prompt for a
switch to diesel. Selecting YES will switch
unit operation back to diesel mode. Pressing
the NO key will allow the unit to remain in
Electric Standby mode even though standby
power is not available. The unit will not run
and Alarm Code 91 Check Electric Ready Input
will be set as a prevent alarm.
Prompt for Switch to Diesel
SWITCHING FROM ELECTRIC TO
DIESEL
If the unit is running in electric and manual
switching to diesel mode is enabled, the unit is
switched using the Diesel Mode Menu. From
the Standard Display, press the MENU key.
(Figure "Menu Key" page 29)
The Language Menu or Alarm Menu will
appear. Press the NEXT key as required to
display the Diesel Mode Menu. When the
Diesel Mode Menu is shown press the
SELECT key.
Select Key
NOTE: This screen will not appear if electric
to diesel autoswitching is enabled.
The unit will return to Diesel Mode operation.
The unit can be programmed to automatically
switch to electric mode operation when standby
power is available. It can also be programmed
to automatically switch to diesel mode
operation if the standby power fails or is
disconnected.
ADJUST BRIGHTNESS
The brightness of the HMI Control Panel
display can be adjusted to allow for changing
ambient light conditions. The choices available
to the operator are HIGH, MEDIUM, LOW and
OFF. OFF actually results in a very dim screen
suitable for low light conditions.
Display brightness is adjusted using the Adjust
Brightness Menu. From the Standard Display,
press the MENU key. (Figure "Menu Key"
page 29)
The Language Menu or Alarm Menu will
appear. Press the NEXT key as required to
display the Adjust Brightness Menu. When the
Adjust Brightness Menu is shown press the
SELECT key.

Table of Contents

Other manuals for Thermo King T- series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermo King T- series and is the answer not in the manual?

Thermo King T- series Specifications

General IconGeneral
RefrigerantR-404A
Voltage12V/24V DC
DefrostElectric or Hot Gas
ModelT-series
Cooling CapacityVaries by model
Power SourceDiesel Engine or Electric
Temperature Range-29°C to 24°C
Control SystemMicroprocessor-based
Fuel Tank CapacityVaries by model
DimensionsVaries by model
WeightVaries by model

Related product manuals