2
© Third Dimension Confidential Document D13-1604-GGUSER-EN-3.4
V7.6
Copyright © 2016 Third Dimension
All rights reserved.
You must not reproduce or distribute any part of this
publication in any form or by any means, electronic or
mechanical, without prior permission in writing from
Third Dimension. This includes photocopying, recording
or any other information storage or retrieval system.
This version produced on 16 September 2016
For support with your GapGun Pro please contact
Third Dimension:
Brabazon Office Park, Bristol, BS34 7PZ, UK
T: +44 (0)3333 44 3000
F: +44 (0)3333 44 0041
E: support@third.com
www.third.com
The laser complies with IEC60825-1 AM2:2001.
Because your blink reflex provides enough protection, it
is called eye safe
• Do not shine in eyes
• Do not view with optical instruments
• Do not shine in open space
• Take care around reflective surfaces
LASER RADIATION
DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS
CLASS 2M LASER PRODUCT
GapGuns running 7.2 software and later by default use the fixed address
10.10.10.1
PCs running SPC3D 7.2 and later should be configured to use the fixed address
10.10.10.255
Network Mask
255.0.0.0
SPC3D 7 and the GapGun 7 software use the TCP/IP communication ports
Firewalls must be set to permit connections on these ports.
NOTE: The GapGun software will not work if these ports are not opened.
TCP/21030
UDP/21030
Inbound and Outbound
GapGun Pro CERDISP and CERHOSTGG5 use TCP/IP communication port
UDP/987
GapGun MX+ CERDISP and CERHOSTGG4 use TCP/IP communication port
TCP/987
Prior to V7.2 the GapGun and SPC3D used these default fixed addresses:
These should be replaced with the new 10.10.10.x addresses where possible.
100.0.0.1
100.0.0.255
To Next Page
Loading...