C2326
C2327
C2328
C2329
Assembly (cont’d)
DRIVE MOTOR 2.12
Pin
Notch
Studs
10 Install the intermediate plate to the housing. (fig.
C2326). Note the alignment pin used to locate the plate to
the notch in the housing.
Cardan shaft
12 Install the cardan (drive) shaft to the output shaft.
(fig. C2328).
13 Note the holes in the intermediate spacer and the
geroler section housing. (fig. C2329). Align these holes
when installing the geroler section to the housing.
11 Install two studs if available to assist assembly. (fig.
C2327).
Holes
Seal
To Next Page
Loading...
