THOMSON MEC 310#GENSET CONTROLLER User Manual

MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 115 THOMSON TECHNOLOGY
10800-10950 Water temp. config. sensor
No. Setting Min. setting Max. setting Factory
setting
10800 VDO Type 1 5 1
10810 VDO 3 Water temp. Input 1 0 ohm 2500 ohm 0 ohm
10820 VDO 3 Water temp. Output 1 0 150 0°C
10830 VDO 3 Water temp. Input 2 0 ohm 2500 ohm 40 ohm
10840 VDO 3 Water temp. Output 2 0 150 40°C
10850 VDO 3 Water temp. Input 3 0 ohm 2500 ohm 60 ohm
10860 VDO 3 Water temp. Output 3 0 150 60°C
10870 VDO 3 Water temp. Input 4 0 ohm 2500 ohm 80 ohm
10880 VDO 3 Water temp. Output 4 0 150 80°C
10890 VDO 3 Water temp. Input 5 0 ohm 2500 ohm 90 ohm
10900 VDO 3 Water temp. Output 5 0 150 90°C
10910 VDO 3 Water temp. Input 6 0 ohm 2500 ohm 100 ohm
10920 VDO 3 Water temp. Output 6 0 150 100°C
10930 VDO 3 Water temp. Input 7 0 ohm 2500 ohm 120 ohm
10940 VDO 3 Water temp. Output 7 0 150 120°C
10950 VDO 3 Water temp. Input 8 0 ohm 2500 ohm 150 ohm
10960 VDO 3 Water temp. Output 8 0 150 150°C
10970-11000 Engineering units
No. Setting Min. setting Max. setting Factory
setting
10971 Unit Set point C/bar F/bar C/bar
10980 Configurable input selection
No. Setting Min. setting Max. setting Factory
setting
10980 Conf inp 1 Set point VDO Binary VDO
10990 Conf inp 2 Set point VDO Binary VDO
11000 Conf inp 3 Set point VDO Binary VDO
Possible selections:
-
VDO
-
4...20mA
-
0…20mA
-
Binary
Thomson Technology reserves the right to change any of the above.

THOMSON MEC 310#GENSET CONTROLLER Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER
Category	Controller
Language	English