THOMSON MEC 310#GENSET CONTROLLER User Manual

MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 5 THOMSON TECHNOLOGY
3. General product information
This chapter includes overall product information about the unit in general and its place in the
Thomson Technology product range.
Introduction
The concept of the MEC 310 is to offer a simple and effective solution to gen-set builders, who
need a flexible yet cost-competitive protection and control unit for small and medium-sized
generators.
Type of product
The Generator Controller MEC 310 is a microprocessor-based control unit containing all necessary
functions for protection and control of a power generator. Besides the control and protection of the
diesel engine it contains a full 3-phase AC voltage and current measuring circuit. The unit is
equipped with an LCD display presenting all values and alarms.
Standard functions
Engine control
•
Start preparation (preheating or prelubrication)
•
Start/stop sequences with selectable number of start attempts
•
Fuel solenoid selection (coil type)
•
Idle speed control
•
Local or remote start/stop
•
Stop sequence with cooling down
•
Command timers
•
Shut down override (fire pump)
•
Fuel logic
•
Running speed detection selectable
o
Generator Hz/V
o
Charger alternator input (W terminal)
o
Binary input (D+)
o
Oil pressure
o
RPM input
Engine monitoring
•
3 configurable inputs, all selectable between
o
VDO or
o
0(4)-20mA from active transducer or
o
Binary with cable supervision
•
6 binary inputs, configurable
•
RPM input, selectable
o
Magnetic pick-up
o
NPN or PNP pick-up
o
Tacho generator
o
Charger alternator W terminal

THOMSON MEC 310#GENSET CONTROLLER Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER
Category	Controller
Language	English