EasyManuals Logo

THOMSON MEC 310#GENSET CONTROLLER User Manual

THOMSON MEC 310#GENSET CONTROLLER
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 40 THOMSON TECHNOLOGY
Function Description
Inhibit 1
Inhibit 2
Inhibit 3
M-logic outputs: Conditions are programmed in M-logic
GB ON (TB ON) The generator breaker is closed
GB OFF (TB ON) The generator breaker is open
Run status Running detected and the timer in menu 6160 expired
Not run status Running not detected or the timer in menu 6160 not expired
Generator voltage >
30%
Generator voltage is above 30% of nominal
Generator voltage <
30%
Generator voltage is below 30% of nominal
MB ON The mains breaker is closed
MB OFF The mains breaker is open
Idle speed Idle speed depends of the engine manufacture
Shutdown override Inhibit if Shutdown override input is active
If an alarm is configured to activate a limit relay, the relay will activate despite the
fact that the inhibit input is ON.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THOMSON MEC 310#GENSET CONTROLLER and is the answer not in the manual?

THOMSON MEC 310#GENSET CONTROLLER Specifications

General IconGeneral
BrandTHOMSON
ModelMEC 310#GENSET CONTROLLER
CategoryController
LanguageEnglish

Related product manuals