EasyManuals Logo

THOMSON MEC 310#GENSET CONTROLLER User Manual

THOMSON MEC 310#GENSET CONTROLLER
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 42 THOMSON TECHNOLOGY
Programming of external I/O’s are done the same way as the inbuilt I/O’s in MEC 310. Using
TPS 300 software.
Only available external I/O’s are listed in Input/Output view. If e.g. one hardware module is
removed, it will also be removed from the list above.
Remember to press “Refresh I/O texts” button after any changes made.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THOMSON MEC 310#GENSET CONTROLLER and is the answer not in the manual?

THOMSON MEC 310#GENSET CONTROLLER Specifications

General IconGeneral
BrandTHOMSON
ModelMEC 310#GENSET CONTROLLER
CategoryController
LanguageEnglish

Related product manuals