MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 89 THOMSON TECHNOLOGY
Parameter list for standard MEC 310 unit without options
Parameter table description
The table consists of the following possible adjustments:
Set point: The alarm set point is adjusted in the set point menu. The setting can be in
percentage of the nominal values.
6221 Hz/V OK timer 6330 Engine heater OFF
6222 Hz/V OK voltage 6560 Cool-down timeout
6223 Hz/V OK frequency 6570 Oil pres. RUN detect
Parameters only configurable from USW
10010 Cmd.1 Days(S)
6700 Diode compensation 10020 Cmd.1 Hour(S)
6940 Alarm LED function 10030 Cmd.1 Minute(S)
6950 Parameter group 1 10040…10310 Cmd.2…..Cmd.8
6960 Parameter group 2 10320-10370 GSM pin code and numbers
6970 Parameter group 3 10470-10610 Fuel level config. sensor
6980 Sleep mode settings 10640-10780 Oil pressure config. sensor
7090 Island test function 10810-10950 Water temp. config sensor
7570-7660 EIC alarms configuration
10970 Unit settings
9116 Password – customer 10980 Multi input 1 selection (VDO/mA/Bin)
9117 Password – service 10990 Multi input 2 selection (VDO/mA/Bin)
10000 Cmd.1 Tim/start/stop 11000 Multi input 3 selection (VDO/mA/Bin)
To Next Page
Loading...
