TIPTEL 330 - Remote Control: Button Functions (Part 3); Room Monitoring, Speaking, and Signal Functions; Interrogation, Capacity, and Interruption Control; Remote ON;OFF of Answering Mode

35
Remote control: button functions
Room monitoring/speaking:
1. Press 8 (stop).
2. Press 1 (room).
3. Press 1 (room) again.
Room signal:
1. Press 8 (stop).
2. Press
❋❋
and 2 afterwards.
Remote interrogation/date and time:
1. Press 8 (stop).
2. Press
❋❋
and 5 afterwards.
Remote interrogation/recording capacity:
1. Press 8 (stop).
2. Press
❋❋
and 3 afterwards.
Stop remote interrogation:
1. Press 8 (stop).
2. Press
❋❋
and # (end) afterwards.
Remote OFF of the answering mode:
1. Press 8 (stop).
2. Press
❋❋
and 0 (off) afterwards.
Remote ON of the answering mode:
1. Call your tiptel 330/331.
2. Enter your remote control code.
The running function stops.
The microphone switches on. You can listen
to what is happening in the surroundings of
your answering machine.
You can switch between room monitoring
and room speaking by pressing this button.
The running function stops. The loudspea-
ker emits a beep tone.
Persons present in the room are informed
that they should take over the call personally.
The running function stops.
A voice day and time stamp is given.
The running function stops.
The answering machine informs you about
the remaining recording capacity.
The running function stops.
The device disconnects the line.
The running function stops.
The device disconnects the line. Further
calls are not answered.
The answering machine emits a beep tone
after approx. 50 seconds.
If the code is identified, the OGM is played
back for verification purposes.
The device is now ready for remote control
operation (e. g. for recording a new OGM).
After you are finished with remote control your
tiptel 330/331 resumes the answering mode
and will answer incoming calls.