TiVo Stream - Host DVRs supported; System requirements

System requirements
TiVo Stream Operator’s Guide v1.0 • TiVo
®
Proprietary and Confidential 5
The LED goes through the following sequence during a normal bootup process:
Steady Amber > Blinking White > Solid White
Once the TiVo Stream downloads the new software, if the TiVo App is in the TiVo Stream guided
setup, it automatically restarts the TiVo Stream; you will need to wait while the device reboots. The
LED goes through the following sequence as the TiVo Stream boots and installs the new software:
Off > Steady Amber > Blinking White > Blinking Amber > Off > Steady Amber >
Blinking White > Solid White
Therefore, the time required for initial setup is longer than normal.
Host DVRs supported
TiVo Stream supports the TiVo Premiere Series of DVR’s (Series 4) running software release 20.2.1
or greater. The following is a list of the currently supported DVRs.
 TiVo Premiere
 TiVo Premiere XL
 TiVo Premiere Q
 TiVo Premiere 4
 TiVo Premiere XL4/Elite
Default group mappings
TiVo Stream has the following default group mappings:
 AP_http
 AP_mrs
 AP_trio
Note: AP_trio will not be present if a customer opted out of the account privacy setting.
 DG_standard
 SF_nopgd
 SF_nouidata
System requirements
The system requirements for TiVo Stream are as follows:
 At least one TiVo Premiere Series (or later) DVR connected via a high bandwidth
hardwired connection (Ethernet or MoCA) to the home wireless router.
Note: The wireless connection is to the mobile devices only.
 TiVo App 2.0 or later.
Note: The TiVo App 2.0 will be available for download on 09/05/2012.