Appendix: NTCIP Configuration
The National Transportation Communications for ITS Protocol (NTCIP) provides a
communications standard that ensures the interoperability and interchangeability of traffic
control and Intelligent Transportation Systems (ITS) devices. This appendix provides
information about the conformance groups which are supported by the HSD820v2H3-E.
In This Chapter
Supported conformance groups.................................................................................. 101
SNMP MIB................................................................................................................103
Supported conformance groups
The HSD820v2H3-E firmware supports all the mandatory parts and some of the optional parts
(see table below) of the NTCIP CCTV specification as laid down in the NTCIP 1205:2001
v01.08 document. This means that - in terms of section 4 of this document - the following
conformance groups are supported.
Conformance group Reference Conformance
requirement
Configuration NTCIP 1201:1996 mandatory
CCTV Configuration NTCIP 1205 mandatory
Motion Control NTCIP 1205 optional
Conformance statement table
Configuration
Most of the Configuration conformance group objects listed below contain static device
information.
● Global Set ID parameter
● Maximum modules parameter
● Module table
● Module number
● Module device node
● Module make
● Module model
● Model version
● Module type
● Base standards parameter
101
To Next Page
Loading...