8.2 Cruise
PTZ&IMAGE > Cruise
A cruise is a route formed with manual operation (through adjusting the pan and tilt position),
which can be stored and recalled to execute repeatedly. The HSD820v2H3-E supports up to
eight programmable cruise paths.
To record a cruise path
1 On the PTZ&IMAGE tab, click Cruise in the menu on the left.
2 Under Cruise setting, select a path number on the Cruise path list.
Note: An existing recording stored under the selected path number will be overwritten
with the new recording.
3 Position the pointer on the live view pane.
4 Keeping the left mouse button pressed, drag the (red) pointer across the live view to
move the camera to the starting point of the cruise path.
5 Click the Set button of Record start.
6 Pan, tilt, and zoom the camera to program the cruise path.
7 When finished, click the Set button of Record end.
To execute a defined cruise
1 On the PTZ&IMAGE tab, click Cruise in the menu on the left.
2 Under Cruise run, select the desired cruise from the Cruise path list.
3 Press Run.
The camera starts panning/tilting/zooming as recorded.
To view the cruise in full-screen mode, right-click the live view pane, and then select
fullscreen.
PTZ&IMAGE
82
To Next Page
Loading...