Valid characters: A-Z, a-z, 0-9, !#$%&’-.@^_~
4 In the Authentication Type list, click MD5 or SHA.
SHA offers a higher security level.
5 Type a password in the Authentication Password box.
Length: Eight characters or more.
For security purposes, characters/numbers are displayed as dots.
Valid characters: A-Z, a-z, 0-9, !#$%&’-.@^_~
6 In the Encryption Type list, click DES or AES.
AES offers a higher security level.
7 Type a password in the Encryption Password box.
Minimum length: eight characters. Maximum length: 512 characters.
For security purposes, characters/numbers are displayed as dots.
Valid characters: A-Z, a-z, 0-9, !#$%&’-.@^_~
Note: The encryption password can be left blank. In that case, however, messages will
not be encrypted.
8 Select Enable SNMP v3.
9 Click Save.
Traps for SNMP v1/v2/v3
Traps are used by the HSD820v2H3-E to send messages to a management system to report
important events or status changes.
To use traps
1 Select Enable traps.
2 In the Trap address box, type the IP address of the management server.
3 In the Trap community box, enter the community to use when sending a trap message
to the management system.
4 If desired, select Warm start.
A Warm Start SNMP trap signifies that the SNMP device - that is, the HSD820v2H3-E,
reinitialises itself by performing a software reload.
5 Click Save.
System settings
40
To Next Page
Loading...