Tolomatic User Guide: ICR Rod Style Integrated Control Actuator 3-7
ICR/ICM SV1P PLUS - ELECTRICAL INTERFACE, SPECS & WIRING
: 3
The ICR/ICM SV1P Plus actuator has two digital outputs, which are programmable.
The outputs are opto-isolated from the drive circuitry and can be configured for
sinking or sourcing. The outputs are protected against over current and short circuit
conditions. Once an over current condition is present, the output turns off until the
load is removed.
ICR/ICM SV1P Plus Digital Output Specifications
Maximum Switched Voltage 30 V
Output low maximum (20 mA sink) 4 V
Maximum continuous current 20 mA
Fold back current 80 mA
Maximum output sink / source voltage 24 V
Update rate 1 ms
Output Leakage Current 10 uA
3.4 Digital Outputs - ICR/ICM SV1P Plus
3.3 Analog Inputs - ICR/ICM SV1P Plus
The ICR/ICM SV1P Plus actuator has one programmable analog input.
ICR/ICM SV1P Plus Analog Input Specifications
Input Voltage Maximum +/- 15V
Input Voltage Full Scale (nominal) +/- 10V
Input Impedance (nominal) 5K Ohm
Input Offset Voltage Maximum +/- 10mV
Input Bias Current +/- 1uA
Update Rate 62.5uS
Figure 3-12: ICR/ICM SV1P Plus Analog Input Circuit
Figure 3-13: ICR/ICM SV1P Plus Analog Input Typical Wiring
-
+
5.36K
37K
37K
REFIN+
REFIN-
REFIN+
REFIN-
DAC
0V
SIGNAL
To Next Page
Loading...