Tolomatic SmartActuator Series - CME 2 User Interface and Tool Bar

Tolomatic User Guide: ICR Rod Style Integrated Control Actuator 6-5
HOW TO USE THE ICR/ICM SV1P PLUS ACTUATOR : 6
6.6 CME 2
®
User Interface and Tool Bar
2. Select the appropriate CAN Card, Channel, Bit Rate, and click Finish.
The CAN Card list shows the manufacturer names of all supported CAN cards
that have been connected to the PC and which drivers have been installed.
All amplifiers must be set to the same bit rate (default is 1 Mbit/s).
The CME 2
®
User Interface features are illustrated in Figure 6-6 below. Screen
details will vary depending on amplifier model and mode selection.
Figure 6-6: CME 2
®
User Interface Features
The CME 2
®
Interface Tool Bar contains 11 icons. Their description and functions
are explained in the table below.
CME 2
®
User Interface Tool Bar Icons and Functions
Basic Setup Icon Opens the Basic Setup Screen.
Control Panel Icon Opens Control Panel.
Auto Phase Icon
Not required because the ICR actuator is pre-set at
Tolomatic.
Auto Tune Icon
Not required because the ICR actuator is pre-tuned
at Tolomatic.
Scope Icon Opens the Scope window.