Tolomatic SmartActuator Series - Diagnostics; Control Panel; Figure 6-11 CME 2 Tool Bar - Control Panel Location

6-10 Tolomatic User Guide: ICR Rod Style Integrated Control Actuator
6 : HOW TO USE THE ICR/ICM SV1P PLUS ACTUATOR
6.9 Diagnostics
6.9.1 Control Panel
The Control Panel is used for general status and control of the ICR Plus actuator.
Use this diagnostic tool to quickly check faults, monitor position, enable/disable, and
initiate simple moves.
To access the Control Panel, click on the Control Panel icon in the tool bar.
Figure 6-11: CME 2
®
Tool Bar - Control Panel Location
2. Optional CANopen
Optional CANopen can be used to communicate with single or multiple ICR Plus
actuators. This command can be received from a PC, PLC, HMI or other device.
For illustrations on setting up the ICR Plus actuator using optional CANopen,
refer to page 3-14. For complete details on CANopen networks, refer to
Section 8: CAN Network Configuration on the CME2_User_Guide.pdf and the
CANopenProgrammersManual.pdf provided on the CD-ROM shipped with the
ICR Plus actuator.
3. DeviceNet
DeviceNet can be used to communicate to single or multiple ICR Plus actuators.
This command can be received from a PC, PLC, HMI or other device.
For illustrations on setting up the ICR Plus actuator using DeviceNet, refer to
page 3-14. For complete programming details and instructions, refer to the
DeviceNetProgrammersGuide.pdf provided on the CD-ROM shipped with the
ICR Plus actuator.