Tolomatic SmartActuator Series - Input Power - ICR;ICM SV1 P Plus; Figure 3-17 ICR;ICM SV1 P Plus Logic and Main Power Supplies

Tolomatic User Guide: ICR Rod Style Integrated Control Actuator 3-9
ICR/ICM SV1P PLUS - ELECTRICAL INTERFACE, SPECS & WIRING
: 3
The ICR/ICM SV1P Plus actuator has the following drive ratings:
ICR/ICM SV1P Plus Internal Drive Specifications
Current - Continuous maximum
1
10 A
Current - Peak
1
20 A
Voltage - Nominal 24-48 V
Over Voltage
2
56 V
Under Voltage
3
20 V
Absolute Maximum Voltage 59 V
Logic Current Draw Maximum (24V)
4
0.11 A
Logic Current Draw Maximum (48V)
4
0.09 A
1
Continuous and peak current ratings are actual motor current and input power supply current.
Achievable continuous current will depend on temperature.
2
Drive will shut down at 56V; any voltage above the absolute max voltage can result in permanent
damage.
3
Drive will turn off below this voltage.
4
Logic current for keep alive, no outputs active.
The drive and logic (keep alive) power share the same ground. Drive logic circuitry
can be powered from the keep alive input or the main drive power. The keep alive
input voltage and the main power inputs have independent power supplies and do
not require the same voltage for operation.
Figure 3-17: ICR/ICM SV1P Plus Logic and Main Power Supplies
3.5 Input Power - ICR/ICM SV1P Plus
CAUTION!
Voltage above the absolute
maximum can result in
permanent damage to the
ICR SV1P internal drive
components.
KEEP ALIVE
+24-48VDC POWER
POWER GROUND
CASE / SHIELD GROUND
HIGH POWER
POWER SUPPLY
24 to 48VDC
+
-
24 to 48VDC
+
-
FUSE
FUSE