6-4 Tolomatic User Guide: ICR Rod Style Integrated Control Actuator
2. To add ports, from the Available Ports list, select the serial ports to be used for
amplifiers and click Add.
3. To remove ports from the Selected Ports list, select the serial ports and click
Remove.
4. Click Next to save selections and open the Communications Wizard Configure
Serial Ports screen.
Figure 6-4: Communication Wizard Configure Serial Ports Screen
5. From the Selected Ports list, highlight the port desired and select a Baud Rate.
Repeat for each port selected and click Finish to save changes.
6.5 Configure CAN Network Parameters
A CAN port can be used to connect the host PC to one or more amplifiers. Use the
following instructions to configure CAN Network settings.
1. In the Communications Wizard Device Selection screen select CAN Network.
Click Next to open the Communications Wizard Configure CAN Network screen.
Figure 6-5: Communication Wizard Configure CAN Network Screen
6 : HOW TO USE THE ICR/ICM SV1P PLUS ACTUATOR
To Next Page
Loading...