Tolomatic User Guide: ICR Rod Style Integrated Control Actuator 6-3
2. For initial communication set up, the Communications Wizard will prompt a
device selection of either Serial Ports or CAN Network.
Figure 6-2: Communication Wizard Device Selection Screen
3. Serial Ports should be selected for RS-232 or DeviceNet control. For these
selections, proceed to 6.4: Configure Serial Port Parameters. If CAN Network is
selected, proceed to 6.5: Configure CAN Network Parameters.
6.4 Configure Serial Port Parameters (RS-232 and DeviceNet)
One or more serial ports on a PC can be used to connect amplifiers. Use the
following instructions to add ports for amplifiers, choose baud rates for the ports,
and remove ports for amplifiers.
This procedure is also used if the amplifier is to run under DeviceNet control. For
more information on DeviceNet setup, refer to the Copley DeviceNet Programmer’s
Guide located on the CD-ROM that shipped with the ICR/ICM Plus.
1. Select Serial Port as the device (see Figure 6-2) in the Communications
Wizard (Tools/Communication Wizard) and click the Next button to open the
Communications Wizard Select Serial Ports screen.
Figure 6-3: Communication Wizard Serial Port Screen
HOW TO USE THE ICR/ICM SV1P PLUS ACTUATOR : 6
To Next Page
Loading...