■
3-94
h) My IP Address setting
(Fig. 1)
(1) My IP Address Setting
Selects either of DHCP (dynamic IP) or MANUAL (static IP) in the IP Setting
Type. When “Manual” is selected, set My IP Address, Sub Net Mask, and
Default Gateway.
(2) “IP Check” button
Performs a duplicate IP address check.
■ When only this instrument and the TOMEY Link Server or a computer running
Data Transfer are connected to the network, the following settings can be
used.
1) Check the computer IP address.
Check and record the IP address and subnet mask of the computer with DATA Transfer installed. Refer
to the DATA Transfer operation manual for details.
2) Set settings on the Instrument.
The settings shown in the table below describe an example when the IP address of the computer with
DATA Transfer installed is “192.168.2.128” and the subnet mask is “255.255.255.0.” The IP setting
method in this case is Manual.
Computer settings Instrument settings
(Local)
IP address
192 168 2 128 192 168 2 129
Check these on the DATA Transfer
screen.
Same value as computer
setting
(＊1)
Subnet
mask
255 255 255 0 255 255 255 0
Check these on the DATA Transfer
screen.
Same value as computer setting
Default
gateway
-------
0 0 0 0
All 0
Host IP
address
-------
192 168 2 128
IP address of computer
*1: An arbitrary number from 1 to 255 excluding numbers used by the computer (128 in this example)
Setting
exam
les
To Next Page
Loading...
